Primary Cementing Basic Knowledge

The objective of a primary cementing job is to place the cement slurry in the annulus behind the casing. In most cases this can be done in a single operation, by pumping cement down the casing, through the casing shoe and up into the annulus. However,
in longer casing strings and in particular where the formations are weak and may not be able to support the hydrostatic pressure generated by a very long colom of cement slurry, the cement job may be carried out in two stages. The first stage is
completed in the manner described above, with the exception that the cement slurry does not fill the entire annulus, but reaches only a pre-determined height above the shoe. The second stage is carried out by including a special tool in the casing
string which can be opened, allowing cement to be pumped from the casing and into the annulus. This tool is called a multi stage cementing tool and is placed in the casing string at the point at which the bottom of the second stage is required. When the second stage slurry is ready to be pumped the multi stage tool is opened and the second stage slurry is pumped down the casing, through the stage cementing tool and into the annulus, as in the first stage. When the required amount of slurry has been pumped, the multi stage tool is closed. This is known as a two stage cementing operation and will be discussed in more detail later.

The height of the cement sheath, above the casing shoe, in the annulus depends on the particular objectives of the cementing operations. In the case of conductor and surface casing the whole annulus is generally cemented so that the casing is prevented from buckling under the very high axial loads produced by the weight of the wellhead and BOP. In the case of the intermediate and production casing the top of the cement sheath (Top of Cement – TOC) is generally selected to be approximately 300-500 ft. above any formation that could cause problems in the annulus of the casing string being cemented. For instance, formations that contain gas which could migrate to surface in the annulus would be covered by the cement.
Liners are generally cemented over their entire length, all the way from the liner shoe to the liner hanger.

Primary cementing knowledge you also to know

Single stage primary cementig

Dual Stage cementing

Cementing on line

Stube in primary cementing

Continue reading :

Downhole cementing equipment

Surface cementing equipment

Leave a Reply