Single Stage Cementing Operation


The single stage cementing operation is the most common type of cementing operation that is conducted when drilling a well. The procedure for performing a single stage cementing operation will be discussed first and then the procedure for conducting a multiple stage and stinger cementing operations will be discussed.

Single Stage Cementing Operation Procedure

In the case of the single stage cementing operation, the casing with all of the required cementing accessories such as the float collar, centralisers etc. is run in the hole until the shoe is just a few feet off the bottom of the hole and the casing head is connected to the top of the casing. It is essential that the cement plugs are correctly placed in the cement head. The casing is then circulated clean before the cementing operation begins (at least one casing volume should be circulated). The first cement plug (wiper plug) shown in picture bellow, is pumped down ahead of the cement to wipe the inside of the casing clean. The spacer is then pumped into the casing. The spacer is followed by the cement slurry and this is followed by the second plug (shut-off plug).

Bottom Plug Using on Single Stage Cementing

top plug primary cementing equipment

When the wiper plug reaches the float collar its rubber diaphragm is ruptured, allowing the cement slurry to flow through the plug, around the shoe, and up into the annulus. At this stage the spacer is providing a barrier to mixing of the cement and mud. When the solid, shut-off plug reaches the float collar it lands on the wiper plug and stops the displacement process. The pumping rate should be slowed down as the shut-off plug approaches the float collar and the shut-off plug should be gently bumped into the bottom, wiper plug. The casing is often pressure tested at this point in the operation. The pressure is then bled off slowly to ensure that the float valves, in the float collar and/or casing shoe, are holding.  The displacement of the top plug is closely monitored. The volume of displacing fluid necessary to bump the plug should be calculated before the job begins. When the pre-determined volume has almost been completely pumped, the pumps should be slowed down to avoid excessive pressure when the plug is bumped. If the top plug does not bump at the calculated volume (allowing for compression of the mud) this may be because the top, shut-off plug has not been released. If this is the case, no more fluid should be pumped, since this would displace the cement around the casing shoe and up the annulus. Throughout the cement job the mud returns from the annulus should be monitored to ensure that the formation has not been broken down. If formation breakdown does occur then mud returns would slow down or stop during the displacement operation.

The single stage cementing procedure can be summarised as follows:

1. Circulate the casing and annulus clean with mud (one casing volume pumped)
2. Release wiper plug
3. Pump spacer
4. Pump cement
5. Release shut-off plug
6. Displace with displacing fluid (generally mud) until the shut-off plug lands on
the float collar
7. Pressure test the casing

Stay tune on our site after here we will discuss about multi stage cementing.

Thanks for Reading Single Stage Cementing Operation

Best regard

Admin petroleum Support

 

Tags:

Rate this article!

author

Author: 

Hero Santoso Effendi Petroleum Engineer From Indonesia, working on oil and gas industry. Bachelor Degree on Petroleum Engineer UPN Veteran Yogyakarta University. Working and learning hard sharing for complete my life. Programmer is my other skill. Find Me on Link below :

Related Posts

One Response

  1. author

    Ciro BatistaApril 27, 2016 at 10:39 pmReply

    Hi,

    My name is Ciro Batista and I am writing my Masters Thesis. I would like to ask your permission to use the Figure \”Single Stage Cementing Operation Procedure\” on my thesis.

    Thank you.

Leave a Reply